Help – Candy Aquaviva 1300, leaking filter !!

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Help – Candy Aquaviva 1300, leaking filter !!

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • October 20, 2008 at 9:28 pm #40360
    drewb
    Participant

    Hi,

    The filter on my Washer Dryer has just started leaking. Its a pretty constant drip but nothing major.

    Is there anything I can buy to fix this. I don’t see a rubber seal and was wondering what the best solution would be?


    Thanks for help in advance.

    Regards
    Drew

    October 20, 2008 at 9:30 pm #265928
    helo_75
    Participant

    other than undoing it, cleaning the thing thoroughly, on the filter housing, and where it sits in the pump, no

    and im sure there only the pump unit itself available

    but well need the production number, from the inside of the door

    October 20, 2008 at 9:46 pm #265929
    drewb
    Participant

    Re: Help – Candy Aquaviva 1300, leaking filter !!

    Model number from door is N 37616562 0142 4087.

    To the untrained eye, it looks like something a rubber gasket would fix. I appreciate its not always as it seems.

    Thanks for the reply.

    Drew

    October 20, 2008 at 11:17 pm #265930
    Penguin45
    Participant

    Re: Help – Candy Aquaviva 1300, leaking filter !!

    06015493 – “filter knob with gasket” appears to available. Contact spares@ukwhitegoods.co.uk for price and ordering.

    Penguin45.

    October 21, 2008 at 11:48 am #265931
    drewb
    Participant

    Thanks for the help. Filter kit ordered.

    I am hoping it is just the screw in plug that needs replacing.

    If I need to replace the full kit, is it an easy job? I dont mind a bit of diy.

    Thanks
    Drew

    October 25, 2008 at 4:01 pm #265932
    drewb
    Participant

    Re: Help – Candy Aquaviva 1300, leaking filter !!

    All sorted. Replaced entire filter and no more leaks.

    Thanks for the help!

    October 27, 2008 at 8:55 pm #265933
    drewb
    Participant

    Not quite there.

    Getting a small drip after the spinning cycle near filter. I have sealed the three hoses connected to the filter with Silicone.

    Any ideas of the cause?

    Thanks

    October 27, 2008 at 9:11 pm #265934
    helo_75
    Participant

    there could be a chip out of the pump housing where the seal fits

    ive seen it before

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.