Hoover HNL6166-80 Bearings

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › Hoover HNL6166-80 Bearings

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • October 27, 2008 at 5:40 pm #40541
    Phidom
    Participant

    Does anyone know what bearings are fitted to this machine? I have part numbers such as 07170838 and 92440122 but would like to know the bearing numbers eg 6206, 6207 etc. Alternatively, is there a bearing kit available?

    October 27, 2008 at 8:09 pm #266773
    lerch
    Participant

    Re: Hoover HNL6166-80 Bearings

    91406201 Seal retainer end 0727
    41024550 Seal retainer from 0727
    09170838 Bearing
    224 24152043 Bearing

    October 27, 2008 at 11:26 pm #266774
    Phidom
    Participant

    Re: Hoover HNL6166-80 Bearings

    I will order Masterpart kit CY05103 and hope for the best. The bearings from GIAS are so expensive I could not do the repair any cheaper than GIAS would charge for a call-out.

    October 31, 2008 at 6:18 pm #266775
    Phidom
    Participant

    Re: Hoover HNL6166-80 Bearings

    Well, CY05103 was not the right kit but I do have the correct bearings in stock. They are 6205 & 6204 and the seal is the same O/D and I/D as a Zanussi 1000 spin seal but 1.5mm thicker. Going by the witness marks on the spider bush there will be adequate penetration of the thinner seal 😀

    October 31, 2008 at 10:34 pm #266776
    leavemetogetonwithit
    Participant

    Re: Hoover HNL6166-80 Bearings

    Phidom wrote: same O/D and I/D as a Zanussi 1000 spin seal but 1.5mm thicker

    Sounds like you might be best to put in 1.5mm of packing behind the seal before pressing it in. Maybe a suitably sized circlip or two?
    Mike.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.