- This topic has 5 replies, 4 voices, and was last updated 17 years, 4 months ago by
.
-
Posts
-
have to visit EW52P a job passed on to me
has any one got a scematic of how hob is fitted to oven base i hate playing mecarno in taking screws out if nor neeed to get hob removed
many thanks
graham
Pull the appliance out, take the two screws out from either side of the front plastic trim.
From behind the cooker take the rear screws holding both side pannels in.
Carefully pull the side pannels away from the body of the appliance until you have enough room to remove the two screws in each side holding up the ceramic hob.
Pull the hob back and it should be free.Hope this helps, this way you dont need to take the side pannels off.
Re: hopoint cooker
Model EW52P
thanks for scew extraction tip
this job was passed om to me as original engineer had not a clue on cookers..found mbc/rcd tripped as soomn as you switched on wall isolator..earth fault found on stat capi;;ary shorted to overheat TOC
re-route cables and fixed with cable ties
tested hob all fine
tested grill and top oven all fine
come to test main oven…heat calling light on with no switch turned, oven element glowing like the sun.. you can turn control on and fan kicks in
so why is oven element getting a feed with no control being set…can we say that the earth short has taken out oven stat also
any wiring diagram would be helpful
many thanks
Graham
Re: hopoint cooker
Very common problem on these type of machines with built in sw & t’stat , coming on when the should be off
- You must be logged in to reply to this topic.