kenwood cooker

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › kenwood cooker

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 1, 2008 at 1:34 pm #41471
    hdltd
    Participant

    Hi can anyone help me
    I have a Kenwood CK410 dual fuel range cooler and the lower fan oven element has blown the problem is HOW DO YOU REMOVE IT ???
    has anyone done it
    Please help
    John

    December 1, 2008 at 8:02 pm #270296
    knobs
    Participant

    Re: kenwood cooker

    Done few of these,the first one had me going a bit !!
    pull the oven out ,take the back off ,you should find 3 screws that should be holding the floor of the oven in place,there should be the same at the front as well.it can be a bit of a job to pull out the floor,i found if i use long nose pliers at the back right hand side of the floor and pull up,it usually works.
    i think its the same cooker as a CDA, once the floor is out its easy to fit the new element.

    December 2, 2008 at 8:14 am #270297
    Lawrence
    Participant

    Re: kenwood cooker

    Ditto
    Did one last week ,but the floor pan was a pig to get out lots of wiggling and levering and then it came out
    Lawrence

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.