Indesit WIL113/aborts program

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit WIL113/aborts program

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 3, 2008 at 12:19 pm #41540
    harley
    Participant

    Yes i know what your all thinking,anyway above model number fill’s for approx 15 seconds then begins draining,easy iron and delay timer light flashes along with the red neon,any suggestions.thermistor,heater and motor brushes ok,no blown tracks or dry solder joints on board.
    Half a pound of semtex would probably cure it but not to be tried in doors.Any help would be appriciated guy’s.

    December 3, 2008 at 12:40 pm #270534
    Martin
    Participant

    Re: Indesit WIL113/aborts program

    harley wrote:Any help would be appriciated guy’s.

    Just run through the error code for the make and model shownhere 😀

    For future reference always check that thread first. 😉

    December 3, 2008 at 5:44 pm #270535
    harley
    Participant

    Re: Indesit WIL113/aborts program

    Thanks for your reply martin,having found the related codes for the widl range lights 1&4 =eprom/set up error,can i assume that the epprom chip and the board will have to be changed.Qualtex out of stock so its of to emw in the morning.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.