miele t650c

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › miele t650c

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 17, 2008 at 1:20 pm #41939
    robbo1973
    Participant

    been here today and the fault is when you set it on the cycle it runs for about 5 secs something kicks in like a fan on the bottom runs for about another 5 secs then goes to end on opening the door no heat.question how do you get into this beast? wrap round cab and is there an easy way to get to the heater?
    never worked on one before.
    cheers chris

    December 17, 2008 at 1:24 pm #271798
    eastlmark
    Moderator

    Re: miele t650c

    its all through the back of the drum, the ring of hex screws you can see and then there are 2 hidden screws either side of the drum bearing that are reachable through the 2 slightly larger holes in the drum rear. (use a torch, you will the the hex heads) The nuts are captive so dont worry about them. Lot easier than it first appears.

    December 17, 2008 at 2:14 pm #271799
    chezza
    Participant

    Re: miele t650c

    if door opens on it’s own, this is usually down to o/heat stat tripping ; check ducting isn’t restricted ( resettable stat on the internal lower ducting )

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.