Hotpoint WD860

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WD860

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • January 5, 2009 at 7:18 pm #42300
    subs
    Participant

    Customer called to say this machine goes through programme, drains and spins until display shows 001 min, and then starts filling again and he cant stop it.
    Done search but cant see anything like this.

    Any ideas.

    Thanks

    Subs

    January 5, 2009 at 7:59 pm #273039
    helo_75
    Participant

    unusual theres no fault code

    id be checking the heater first

    then your lookin @ pcb ( surprise surprise )

    January 5, 2009 at 8:51 pm #273040
    lerch
    Participant

    Re: Hotpoint WD860

    helo_75 is quite right I have had this alot of times and 99{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} it is the heater for some reason hotpoint put a feed though the heater on spin.

    January 5, 2009 at 9:00 pm #273041
    subs
    Participant

    Re: Hotpoint WD860

    Cheers guys!

    Ill check it out tomorrow.

    Thanks

    Subs

    January 6, 2009 at 8:20 pm #273042
    subs
    Participant

    Re: Hotpoint WD860

    Went to this machine today.
    Machine has a bit of water in it (customer had bailed rest out).
    The dimly lit display (cus says its always been that way since they moved in)shows 001. Turn machine on at plug on/off button lights up. Close door and machine locks and starts ramping up to spin all by itself without pumping out the little bit of water that is left in it. Pressing stop or cancel does nothing just bleeps. No buttons work at all. After machine finishes spinning it just tumbles. Screen still shows 001 and on button still lit but cannot turn off or cancel. If you turn off and on again from plug it does same again. Checked every thing, plus removed both boards and tightened everything up.The question is display board or main board or both?

    Thanks

    Subs

    January 6, 2009 at 8:55 pm #273043
    leavemetogetonwithit
    Participant

    Re: Hotpoint WD860

    If the customer’s happy with a re-con module then it’s got to be EMW and return the one you don’t need.
    Mike.

    January 7, 2009 at 6:29 am #273044
    Flyman
    Participant

    Re: Hotpoint WD860

    Had this on a similar machine and it was caused by an earth fault on the motor.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.