Hotpoint WMA31

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMA31

Viewing 9 posts - 1 through 9 (of 9 total)
  • Author
    Posts
  • February 6, 2009 at 7:08 pm #43218
    mike100
    Participant

    This washer in an outhouse where after the freeze one of the pipes burst and apparently sprayed water over it.
    Then all it would do is the door lock light flashed.
    I tryed a new interlock and it was the same.
    Then I put in an identical board Part No.1604321 and it all worked immeadiately.
    Got a call back next day, she didn’t know when but it had stopped in mid cycle full of water and door light flashing again.
    I checked brushes they are ok.
    Has the board gone again or am I missing something.
    Any help appreciated thanks.
    Mike

    February 6, 2009 at 7:13 pm #276460
    kiddo66
    Participant

    Re: Hotpoint WMA31

    Did you programme the board up for that machine?

    February 7, 2009 at 8:22 pm #276461
    mike100
    Participant

    Re: Hotpoint WMA31

    Hi,
    I didn’t think it was necessary as it was an identical to the replacement.
    Also it worked ok as soon as I fitted new one.
    any other ideas .
    thanks,Mike

    February 7, 2009 at 8:50 pm #276462
    Turbo
    Participant

    Re: Hotpoint WMA31

    Sure you would have had to programme that board, was there not an instruction sheet supplied?
    Graham

    February 8, 2009 at 12:03 am #276463
    iadom
    Moderator

    Re: Hotpoint WMA31

    mike100 wrote:
    I didn’t think it was necessary as it was an identical to the replacement.

    That board fits at least 16 different models, if you don’t have the config codes I can let you have them.

    Jim.

    February 8, 2009 at 8:46 am #276464
    dpr1974
    Participant

    Re: Hotpoint WMA31

    iadom wrote:

    mike100 wrote:

    I didn’t think it was necessary as it was an identical to the replacement.

    That board fits at least 16 different models, if you don’t have the config codes I can let you have them.

    Jim.
    Hi Jim, is it possible to get a copy of those config codes?, i don’t need them yet but it would be great to have the information ready when i do. Thanks

    David

    February 8, 2009 at 3:06 pm #276465
    iadom
    Moderator

    Re: Hotpoint WMA31

    Sent you what I have. 🙂

    Jim.

    February 8, 2009 at 5:54 pm #276466
    mike100
    Participant

    Re: Hotpoint WMA31

    Hi guys,
    Yes I do have the configuration codes. I just thought that having fitted the same board it would be ok as it started alright. Now it stopped full of water and door lock started flashing again.
    I will go back and see if it will let me configure.
    Cheers Mike

    February 10, 2009 at 6:35 pm #276467
    Andystu
    Participant

    Re: Hotpoint WMA31

    Without stating the obvious.!!, did you put the old interlock back on or leave the new one on?. These interlocks as you probably know are great for blowing the boards, so always prudent to fit new interlock anyway.

    Andy Stu

  • Author
    Posts
Viewing 9 posts - 1 through 9 (of 9 total)
  • You must be logged in to reply to this topic.