- This topic has 4 replies, 5 voices, and was last updated 17 years, 1 month ago by
.
-
Posts
-
Called to this condenser dryer which was making a vibrating noise. The noise was caused by a small rubber bellows seal behind the rear fan, on the motor shaft. I put a small dab of grease on it, which cured it. (for the moment)
Would it be better to replace it, or remove it? (what cr@p design). Any suggestions apprieciated.
Re: White Knight 767C T/D
I had to completely dismantle that model the other day to fit a new front fan. There was no such bellows on the one I did just a felt shield around the shaft :?. It seemed to work fine after the repair.
Mike.Re: White Knight 767C T/D
Hiya,
No bellows on mine, just the felt pad in the shape of a cross.Brian 😀
Re: White Knight 767C T/D
The felt bellow was supercided by the rubber one and they are crap. Dont remove it though or it will cause the bottleswitch to warp at the top. I have had a load of these seals coming off or spliting allowing steam to escape up the back and melt the switch, I always re-fit the old felt type seal when replacing bottle switch.
- You must be logged in to reply to this topic.