Zanussi ZWF1432S dead.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZWF1432S dead.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • February 16, 2009 at 10:00 am #43505
    iadom
    Moderator

    ENR 914521109-00

    Apparently worked perfectly on last wash, now if you switch on the mains neon illuminates then nothing, zilch, zippo.

    It will not enter diagnostics at all.

    No obvious signs of damage, brushes look OK etc.

    I’m guessing one pf the PCB’s has failed?

    Any previous on these?

    Jim.

    February 16, 2009 at 2:43 pm #277485
    Martin
    Participant

    Re: Zanussi ZWF1432S dead.

    iadom wrote:Any previous on these?

    Sounds like the same problem as this? 🙁

    February 16, 2009 at 3:38 pm #277486
    iadom
    Moderator

    Re: Zanussi ZWF1432S dead.

    Does sound very much like it, 😥 oh well, another one bites the dust.

    Jim.

    February 16, 2009 at 11:04 pm #277487
    SL
    Participant

    Re: Zanussi ZWF1432S dead.

    Try this trick.

    There is a blue lead running from the main pcb on the side to the front interface pcb.

    Disconnect this lead from both pcb’s and fit the end that was on the interface to the main pcb and vice versa.

    It may come back to life.

    These lead carry low voltage and are prone to poor connections.

    Our guys carry these as van stock.

    February 16, 2009 at 11:14 pm #277488
    iadom
    Moderator

    Re: Zanussi ZWF1432S dead.

    Thanks for that, will give it a go. :tup:

    February 17, 2009 at 6:29 pm #277489
    sparepart
    Participant

    Re: Zanussi ZWF1432S dead.

    Hi, I did post on the other zanussi thread that there are a couple of boards (new) on ebay for £15 each , did post part numbers , dunno if it helps ?
    Alan !

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.