Hoover HWD120 – 80 washer drier PCB woes.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HWD120 – 80 washer drier PCB woes.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 16, 2009 at 9:46 pm #43531
    aqualectric
    Participant

    Hoover HWD120 – 80 washer drier. No. 31001037 0520 0281.

    The usual fault with Candy washer driers – condenser pipe ruptures; water everywhere. Annoying but not serious.
    Until……..the factory forgot to fit the water splash guard on the lower PCB and it got drenched. The result is a machine that will not programme. Switch on, set to program, press the start button and it stays on “Stop” but the door locks. 😕
    Both the lower board and the main PCB look fine, I’ve cleaned the connections and refitted the plugs; still dead.
    I am thinking main PCB: but what does the small lower PCB do? If it got water damaged would the main PCB be affected?
    I also cannot find the part number for the main PCB.

    Any help please!!

    Thanks,

    Steve.

    February 16, 2009 at 9:55 pm #277585
    Penguin45
    Participant

    Re: Hoover HWD120 – 80 washer drier PCB woes.

    09200694 – core board – programmed
    41014754 – dryer board.

    Chris.

    February 16, 2009 at 10:19 pm #277586
    aqualectric
    Participant

    Re: Hoover HWD120 – 80 washer drier PCB woes.

    Thanks, Chris!!
    Is it likely to have blown both boards? And why has the drier got it’s own stand alone PCB?

    Cheers,

    Steve.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.