- This topic has 5 replies, 3 voices, and was last updated 17 years, 1 month ago by
.
-
Posts
-
NN-A873S 1000W MICROWAVE Fitted new magnetron , will only run for about 30 secs then says , Refere to operating instructions before use ?
now i have fitted loads of mags to the inverter systems but this one is
doing my head in , could it be a faulty mag , never had a faulty one before. is there a reset i have to do ? any advice guys
thanks inadvance philRe: panasonic inverter
if you call paul at AWI, he has great knowlege on all these (01983 0817220)
sounds like an inverter fault to me.Re: panasonic inverter
long shot
from what you say the boards seems to be resetting had this happen on other microwaves when there is a crack in mag magnets and the leakage was affecting the electronics
hope this helps
Dave
Re: panasonic inverter
bzz67 wrote:if you call paul at AWI, he has great knowlege on all these (01983 0817220)
sounds like an inverter fault to me.yer paul was my 1st call , still wating for a call back , have fitted 3 mags to it now 1 from a repair that came in that i no that works and a new one from stock and a good s/hand 1 , all the same cuts out at 30 secs , this gets worse i fitted inverter board to it and its the same :bang:
thanks phil
Re: panasonic inverter
nice fault hope you find a solution before you pull all your hair out lol 😆
Re: panasonic inverter
Well i finaly cracked it a little over site again , it was the cam on the air flow flap had melted it was not energizing the micro switch ,
- You must be logged in to reply to this topic.