hotpoint wd420

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › hotpoint wd420

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 1, 2009 at 12:14 pm #43857
    tedd
    Participant

    went to a call yesterday the door was stuck locked so i changed interlock. problem is when the machine is switched on at the mains the machine still wont open but when switched off it does so this leads me to conclude it is not the interlock at fault.also customer done a wash with no probs but the door light flashed all thru the cycle.any ideas regards tedd

    March 1, 2009 at 1:10 pm #278845
    Madmac
    Participant

    Re: hotpoint wd420

    Has to be a short circ in wiring to lock (unlikely?) or panel keeping lock energized when it shouldnt i would think, not something i’ve come across though.

    March 1, 2009 at 7:12 pm #278846
    franz
    Participant

    Re: hotpoint wd420

    Have had this a few times – if it is not the interlock then I’m afraid it’s the PCB
    Franz

    March 1, 2009 at 9:50 pm #278847
    tedd
    Participant

    Re: hotpoint wd420

    thanks for the advice.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.