beko door seal

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › beko door seal

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 9, 2009 at 10:16 pm #44081
    superspin
    Participant

    hi all have been out to this beko wma765s washer today
    needs door seal ,have orderd one but not fitted one of these type yet looks awkward. theres a concreat block running all the way around were the seal fitts no room for fingers, hope the front comes off. any advise before i return. thanks wayne.

    March 9, 2009 at 10:37 pm #279725
    A1engineer
    Participant

    Re: beko door seal

    front comes off, open filter door, 2 screws and plinth moves right then out.
    3 screws at bottom of front panel hold it on, undo door lock and seal and push panel down it is clipped on and both sides.

    you need to remove concrete block 5 torq bolts hold it on it is a pig to get off even with bolts removed might be best to remove facia panel 1st but you cna squeeze it past.

    once weight is removed remove the hose at top and spring clamp round seal, refit new seal and rebuild in reverse,

    good luck you’ll need it 😉

    March 9, 2009 at 10:44 pm #279726
    iadom
    Moderator

    Re: beko door seal

    Just like an ISE 5 mk1, it will be a doddle for someone with Bosch experience. 😉

    I have removed quite a few of these weights without any difficulty at all. 😕 Just don’t drop it, they do break easily if you do. 😉

    20 minutes tops. 🙂

    Jim.

    March 10, 2009 at 11:02 pm #279727
    superspin
    Participant

    Re: beko door seal

    thansks lads thats a great help

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.