Hotpoint drier – UK Whitegoods

This topic has 8 replies, 5 voices, and was last updated 17 years ago by waters.

Viewing 9 posts - 1 through 9 (of 9 total)

Author

Posts
March 21, 2009 at 6:43 pm #44429

waters
Participant

CTD80 gives error code F13.White spot thermostats replaced but still no heat and f13

March 21, 2009 at 7:59 pm #280946

Specialist01269
Participant

Re: Hotpoint drier

Hi: You replaced the stats & obviously checked the element for continuity.
Have you replaced the NTC & checked the wiring back to the board?
Andy.

March 21, 2009 at 8:04 pm #280947

waters
Participant

Re: Hotpoint drier

It only has the 2 thermostats and the heater.There is no ntc in the middle

March 21, 2009 at 8:57 pm #280948

helo_75
Participant

then put a new heater in with s on it

its an ntc problem

March 22, 2009 at 8:43 am #280949

Martin
Participant

Re: Hotpoint drier

waters wrote:It only has the 2 thermostats and the heater.There is no ntc in the middle

What’s the serial no of the machine?…and I’ll give you the correct part no for the heater assy you need. 🙂

March 22, 2009 at 12:59 pm #280950

waters
Participant

Re: Hotpoint drier

SN 510070212
9531357000

March 28, 2009 at 6:30 pm #280951

waters
Participant

Re: Hotpoint drier

do i replace the heater with the same with 2 stats or the one with 3

March 28, 2009 at 7:35 pm #280952

helo_75
Participant

doesnt matter, but your supposed to put the one with 3 on

March 31, 2009 at 7:37 pm #280953

johnnyj
Participant

Re: Hotpoint drier

As Helo says change the heater, if the heater and stats have had a good soaking you will get various thermistor faults, i’ve had a few recalls just fitting the stats trying to keep the cost down only to go back and fit a heater assy, JJ
Author

Posts

Viewing 9 posts - 1 through 9 (of 9 total)

You must be logged in to reply to this topic.