Disassemble Dyson Cyclone Assembly??

Home › Forums › Public Support Forums › Help And Support › Vacuum Cleaner Help Forum › Disassemble Dyson Cyclone Assembly??

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 31, 2009 at 5:41 am #44649
    builder
    Participant

    Hello, Everyone!

    My first post in this forum……my Dyson DC-17 Animal sucked up a small animal….(no joke, no pun intended,) which is lodged inside the cyclone unit and smelling to high heaven!

    I need to disassemble the cyclone, as soon as possible, to remedy this! The problem is, two of the four screws at the bottom stage of the cyclone are off to the side, close to the perimeter of the unit, just out of reach of any typical straight-shanked screwdriver.

    Before I go searching the planet for a flexible screwdriver, I’m hoping someone here has sucessfully made such a repair, and can advise me if I am perhaps missing something, regarding the lay-out of the screws inside this cyclone unit.

    Anyone?

    Thanks so much!

    Mark in the United States, where the mice are very small and very easily sucked up!

    March 31, 2009 at 7:48 am #281779
    kladave
    Participant

    Re: Disassemble Dyson Cyclone Assembly??

    Hi

    Don’t want to appear unhelpfull but the dc17 is only sold in the states,so the peeps over here have no knowledge of your model.

    Dave

    March 31, 2009 at 2:14 pm #281780
    builder
    Participant

    Re: Disassemble Dyson Cyclone Assembly??

    I was presuming this Forum is viewed world-wide, as such I’m hoping for someone with a similar experience to post a reply…..??

    Thanks!

    Mark

    March 31, 2009 at 3:58 pm #281781
    iadom
    Moderator

    Re: Disassemble Dyson Cyclone Assembly??

    Whilst we don’t usually advise duplicate posts as it can often lead to consusion, in this instance it might be a good idea to stick your question in here as well. 😉

    USA forum

    Jim.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.