Hotpoint CTD40

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint CTD40

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • April 1, 2009 at 4:18 pm #44696
    rocker
    Participant

    Have low heat on all settings have tested heating elements ok, the two black stats are fine but the white stat is open circuit, not sure if this correct as this goes to pcb.
    could anyone please let know as I feel this may be the fault.
    Cheers John.

    April 1, 2009 at 4:23 pm #281962
    Martin
    Participant

    Re: Hotpoint CTD40

    The white stat is in fact an NTC Thermistor which will show resistence values in K Ohms. 😉

    April 1, 2009 at 9:14 pm #281963
    rocker
    Participant

    Re: Hotpoint CTD40

    Martin,
    Thanks for your help. first time I have came accross this type. john

    April 2, 2009 at 3:31 pm #281964
    Specialist01269
    Participant

    Re: Hotpoint CTD40

    Hi: Rear NTC should read approximately 500 Kilohms at room temperature (20 deg c) also check the wiring between thermistor & board as this has a habit of going o/c.

    April 3, 2009 at 6:25 am #281965
    rocker
    Participant

    Re: Hotpoint CTD40

    Specialist,
    have tested wiring to pcb, will test temperture as you advised. but will a faulty ntc cause a low heat fault.!!
    cheers John

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.