W’pool ADG7540/1

Home › Forums › Trade Technical & Spare Parts Forums › Trade Spare Parts › W’pool ADG7540/1

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • April 3, 2009 at 11:56 pm #44754
    clivejameson
    Participant

    8542 540 15810

    This one needs a pcb, SIOS shows it as 481228138615 which doesn’t seem correct…the board supplied has an extra connection for the OWI which isn’t present on this model and so gives an E11 error when fitted (faulty OWI) 😕

    Has anyone come across this before and if so what is the correct board for this one?

    Cheers

    April 4, 2009 at 12:18 am #282197
    Penguin45
    Participant

    Re: W’pool ADG7540/1

    I get 4812 218 38174 if that’s any help.

    Chris.

    April 4, 2009 at 12:21 am #282198
    clivejameson
    Participant

    Re: W’pool ADG7540/1

    Thanks Chris, that’s the new recoded part number? We ordered that one and it came through as the same incorrect one. This customer is getting jumpy having been without the machine for weeks…it transpired he’d had another repairer in who’d strung him along then done a runner and now I know why oh joy 😕

    April 4, 2009 at 12:29 am #282199
    Penguin45
    Participant

    Re: W’pool ADG7540/1

    JM11 will probably know definatively……….

    Chris.

    April 4, 2009 at 9:28 am #282200
    johnmac11
    Participant

    Re: W’pool ADG7540/1

    It is the correct pcb and if you have 11 flashes it means either faulty OWI or WI, this machine has a WI switch fitted, check that to make sure it is working OK.

    John

    April 5, 2009 at 9:17 pm #282201
    clivejameson
    Participant

    Re: W’pool ADG7540/1

    Thanks for that John…

    A little history to this one….the original fault was a no heat fault although the machine completed the cycle and gave no error reading so I took the belt and braces approach to replace both the ntc and then the pcb. The replacement pcb has slightly different orientation to the edge connectors including an additional space for an OWI connector. The new board immediately gives an E11 error on power-up (this fault not present on the original board)

    So….i suspect the model/service number may be incorrect so any advice about similar models that may have the same pcb would be welcome…or indeed if anyone has the contact number of a techie within W’pool that may have an answer?

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.