zanussi ZWD1680W

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi ZWD1680W

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 4, 2009 at 1:54 pm #44766
    LittleMan
    Participant

    Hi
    This washer dryer will flash e10 after about 10 min on drying prog
    could this be the condensor inlet valve

    can any one help please
    Many thanks Les

    April 4, 2009 at 3:36 pm #282239
    Specialist01269
    Participant

    Re: zanussi ZWD1680W

    Hi: E10 is the user error code for cycle paused, due to any of the following:
    1) Poor water pressure
    2) Faulty inlet valve
    3) Fault in pressure system or switch
    4) Bad interconnection wiring
    5) PCB faulty
    Normally in that order, HTH[/img]

    April 4, 2009 at 5:48 pm #282240
    leavemetogetonwithit
    Participant

    Re: zanussi ZWD1680W

    The coils on these valves can measure OK when you check them but go o/c when they warm up. Common problem; must be ’cause I’ve seen it twice.
    Mike.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.