- This topic has 5 replies, 2 voices, and was last updated 16 years, 10 months ago by
.
-
Posts
-
hi
we put our smeg dishwasher on lastnight and for the 1st time in a long time it didnt finish the program.
the 2 outer lights are off and the inner 2 lights are on,.any one know what this fault is ??
Re: smeg fault codes not in manual
It sounds as if it’s stuck in the test cycle, either that or there’s a weird fault I can’t see listed which will often point toward a board failure on those machines.
To reset it…
Switch off the machine
Repeat the procedure to restart the test cycle (open the door and switch on the machine and within 3 sec press 4 times the button “Start/Pause”)
switch off the machineThe test cycle is reset, it is possible to select any programme.
If that doesn’t clear it then it’s a pukka fault and, as I said, probably with the PCB although there are other possibilities.
HTH
K.
Re: smeg fault codes not in manual
ok.
ill try that when i get back from work and give you results then .
cheers
- You must be logged in to reply to this topic.