WHIRLPOOL d/w ADP4501 fills for 1 min then dr/pump activates

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › WHIRLPOOL d/w ADP4501 fills for 1 min then dr/pump activates

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • June 1, 2009 at 12:12 pm #46109
    grazzamongrel
    Participant

    hi, i have a whirlpool dishwasher and it selects the programme fine then it pumps for 30 secs aprox then fills with water for 1 min aprox then pump comes back on and start button flashes 6 times according to customer, any ideas??

    where is the pressure switch on these?? and flow meter etc.

    graham

    June 1, 2009 at 7:27 pm #288257
    Jazzmeister
    Participant

    Re: WHIRLPOOL d/w ADP4501 fills for 1 min then dr/pump activ

    Probably flashes 7 times and it would be the flow switch..located on the fill chamber on the left hand side of the appliance as you look at it!
    Had exactly the same fault last month and was a bitch to locate 😆
    Hope this helps..

    Jazz

    June 1, 2009 at 8:59 pm #288258
    clivejameson
    Participant

    Re: WHIRLPOOL d/w ADP4501 fills for 1 min then dr/pump activ

    …and if it’s a flow meter problem the nine times out of ten it’s just a poor connection to it, clean the little pcb tracks on it and crimp up the connector block.

    June 1, 2009 at 9:35 pm #288259
    grazzamongrel
    Participant

    Re: WHIRLPOOL d/w ADP4501 fills for 1 min then dr/pump activ

    thanks for the reply chaps will let you know what i find.

    June 8, 2009 at 4:29 pm #288260
    grazzamongrel
    Participant

    Re: WHIRLPOOL d/w ADP4501 fills for 1 min then dr/pump activ

    i couldnt even get the lid off to get side panel off.cust watchin like hawk so couldnt really knock it about much

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.