Zanussi ZWD1680W Error 10

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Zanussi ZWD1680W Error 10

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • June 21, 2009 at 8:59 pm #46525
    pleo2005
    Participant

    I have a Zanussi ZWD1680W thet come up error 10 after about 10 mins on the drying cycle. Is there a way to fix this before I but another washer/dryer. Thanks

    June 21, 2009 at 11:14 pm #289868
    Penguin45
    Participant

    Re: Zanussi ZWD1680W Error 10

    E10 faults are related to water. Your machine being a washer dryer I would start by checking that the water valve is allowing water to trickle in during the drying phase. Remove lid and observe the square section pipe running across the top of the machine at the rear.

    Don’t touch anything before pulling the plug.

    Penguin45.

    July 11, 2009 at 7:20 pm #289869
    pleo2005
    Participant

    Re: Zanussi ZWD1680W Error 10

    I took the lid off and set it to dry, there was no water going through the pipe. The drum would start spinning for about 15 sec, stop, then start again for 15 sec. This goes on for about 10 mins then it comes up with error 10. The clothes inside were still cold as if the dryer part isn`t heating up. Could it be a thermostat problem ?

    Any more ideas before I buy a new washer/dryer

    July 11, 2009 at 8:47 pm #289870
    helo_75
    Participant

    yes.. the valves faulty as penguin said

    its a £20 part

    http://shop.ukwhitegoods.co.uk/Washing+ … Valve.html

    its the green coil thats open circuit, the machine wont allow it to continue because theres no point if it aint gonna work

    July 11, 2009 at 10:10 pm #289871
    pleo2005
    Participant

    Re: Zanussi ZWD1680W Error 10

    Thanks for that. Are they easy to fit ? Where would it be located ?

    Thanks again

    July 11, 2009 at 10:20 pm #289872
    Grendal
    Participant

    Re: Zanussi ZWD1680W Error 10

    Its the part that connects to the water inlet hose dont forget unplug before you touch anything

    July 12, 2009 at 4:33 pm #289873
    pleo2005
    Participant

    Re: Zanussi ZWD1680W Error 10

    I have ordered the part, I will let you know how I get on.

    July 16, 2009 at 5:24 pm #289874
    pleo2005
    Participant

    Re: Zanussi ZWD1680W Error 10

    Thanks to Penguin45 and helo_75.

    I changed the part today and I now have a washer/dryer that works now. Thanks again

    Hope this helps anyone else who has the same problem.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.