Hoover Fault Codes

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover Fault Codes

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 30, 2009 at 8:24 am #46715
    neilsukwg
    Participant

    VHD 8142

    Trying to figure out the fault code on this machine,
    Machine fills, the Time Saver Light Flashes 2x pause 2x etc.

    Not sure of which error code this signifies, even after reffering to page 43 ukwg fault code book?

    June 30, 2009 at 9:41 am #290599
    loopey
    Participant

    Re: Hoover Fault Codes

    The time for the displaying of each code, is 15
    seconds. During this period of time, both LEDs flash
    together at the frequency of 1 Hz (one flash per
    second), for a number of times corresponding to the
    number of the error to be displayed. Then, they stay
    OFF for all the time that’s missing to the end of the
    period of 15 seconds. The sequence is repeated until
    Service Intervention or until the machine is switched
    OFF.
    Example: Error Code Number 2 (missing completion
    of the water load within the designed limit
    time) is displayed as follows:
    • 2 flashes by the 2 LEDs together, in
    the first 2 seconds of the period of 15
    seconds (0.5″ ON – 0.5″ OFF)
    • For the remaining 13 seconds, both
    LEDs stay of OFF.
    • The sequence as above, is repeated.
    ERROR 2
    The Water Fill Phase was not completed within the designed limit time. Defective
    Solenoid Valve, Pressostat, Water Fill Hose, Low Water Pressure in the network
    and/or Wiring.

    hope this helps
    phil

    June 30, 2009 at 6:02 pm #290600
    neilsukwg
    Participant

    Re: Hoover Fault Codes

    Thanks very much.

    Going wednesday so can home in on problem now.

    Neil

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.