Zanussi ZT 685 draining problem ..

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Zanussi ZT 685 draining problem ..

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • July 2, 2009 at 2:51 pm #46783
    lasty
    Participant

    Zanussi ZT 685 dishwasher is giving me a bit of grief …
    select any programme and the machine fills fine , washes but will leave a few litres of water in the bottom and flash the `not empty` fault . No blockages but it seemed to empty slowly and in pulses without much pressure . I changed the circulation / drain motor which came with a new impellor but still the same ….
    would be grateful for any info if anyone has anything similar .

    Cheers …

    July 2, 2009 at 3:58 pm #290880
    bzz67
    Participant

    Re: Zanussi ZT 685 draining problem ..

    usually just get blocked in the sump under the filters, you can just get your fingers in around. but you may have already tried that.

    July 2, 2009 at 7:04 pm #290881
    Penguin45
    Participant

    Re: Zanussi ZT 685 draining problem ..

    Reversing motor – drain impellor will be stripped.

    Chris.

    July 4, 2009 at 12:07 pm #290882
    lasty
    Participant

    Re: Zanussi ZT 685 draining problem ..

    Thanks for the answers . Penguin chris – New motor had an impellor fitted , checked it was tight and installed with the motor so hopefully ruled out that one . bzz667 i Had a grope around and all seemed clear in the filter area but i`ll try getting a really good look . i`m due around again next week so we`ll see …

    Thanks again ..

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.