Bosch won’t stop filling

Home › Forums › Public Support Forums › Help And Support › Dishwasher Help Forum › Bosch won’t stop filling

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 10, 2009 at 2:58 pm #47687
    will69
    Participant

    Model: SGV53E03GB/72

    My 2-3 yr old Bosch dishwasher has developed a fault. At start of cycle, after first pumping out, the machine starts to fill then won’t get past filling cycle. Water inlet will run, drain pump runs, water stops, float falls, starts filling again, drain pump runs …. etc…

    When opening door I get the little tap light on (check water supply indicator) – manual says this means:
    Tap turned off – NO
    Water supply interupted – Do not believe s0
    Filter in water supply blocked – taken out and cleaned, looks ok
    Supply hose kinked – looks OK

    I have checked:
    Drain pump runs OK, pumps out fine, no blockages on drain inside machine.

    Runs through 15min rinse cycle OK, so water getting into machine.

    No water in base.

    Any ideas??

    August 10, 2009 at 5:55 pm #294263
    Penguin45
    Participant

    Re: Bosch won’t stop filling

    Flow meter is probably defective – p/no 424099 – this little chap HERE in fact.

    Penguin45.

    August 10, 2009 at 7:00 pm #294264
    will69
    Participant

    Thanks for the quick reply. I will try replacing the flow meter.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.