Creda Cooker Model Collection C366E

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Creda Cooker Model Collection C366E

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • August 24, 2009 at 3:46 pm #48028
    Brains
    Participant

    Good Afternoon All

    Got a call to do tomorrow on one of the above.

    Reported fault of oven switches on when a hob ring is being used.

    Any ideas as to the fault? Am I looking at a faulty regulator for the oven?

    Any help would be appreciated.

    Thanks

    Regards

    August 24, 2009 at 4:43 pm #295332
    Phidom
    Participant

    Re: Creda Cooker Model Collection C366E

    Perhaps a detached or burnt out neutral wire. Could also be a short circuit somewhere. A megger tester would be useful if you have one.

    August 24, 2009 at 4:47 pm #295333
    Brains
    Participant

    Re: Creda Cooker Model Collection C366E

    Phidom

    Hmmm………. I was wondering if it was a burnt-out neutral. I do have all the required test gear – Megger, Loop tester etc.

    On the other-hand, if the oven control was in the ‘off’ position, can’t see how it work unless the controller had failed shorted? Any thoughts?

    Regards

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.