AEG 86741 C9 Fault code

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › AEG 86741 C9 Fault code

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 1, 2009 at 6:41 pm #48237
    nelson
    Participant

    Called out to this today, I checked the known error codes to find C9 is a motor tacho / motor or brushes fault. Checked the motor, no faults found, Tacho intact, wiring ok and brushes nice and long…. Am I missing something? When the machine displays the C9 fault it also flashes the pre-wash and rinse+ leds (1 & 4 from top to bottom) is this indicating something else? Any help much appreciated.

    Cheers

    September 3, 2009 at 4:18 pm #296033
    electrofix
    Moderator

    Re: AEG 86741 C9 Fault code

    light indicate the same thing if display not there use light to get code

    from lux info

    c9 = tachometer pulses are missing

    check drive motor
    carbons
    tacho gen
    wiring


    fault is listed as can only used again after a test routinr is started coulb you have to go into test and out again to reset

    try hold prewash and sensitive buttons and keeping them pressed turn rotary knob to energy saving

    this should start a test prog and reactivate machine

    have got manual can emal it to u if you get stuck but may b next week full model of machine should be LAV86741

    hope this helps

    Dave

    September 3, 2009 at 8:16 pm #296034
    nelson
    Participant

    Re: AEG 86741 C9 Fault code

    Cheers Dave, I’ll give the test routine a try. 🙂

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.