Hotpoint WMA34P

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hotpoint WMA34P

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 10, 2009 at 2:23 pm #48495
    jackster
    Participant

    Hi all. I have got the above model wm in my worksop as we speak with what was originally a dodgy motor. I have replaced the motor and all is well on that front, unfortunateley it now doesnt want to drain. If I put it on a spin it spins ok but there is no drain, I replaced the pump but still no joy. I am getting 58v to the pump which leads me to suspect the main board. I have also been getting the wash & end led’s flashing whicj I assume is a fault code? Please forgive me It is the first time I have worked on these WM machines. Anyone help?

    September 10, 2009 at 2:46 pm #296746
    Phidom
    Participant

    Re: Hotpoint WMA34P

    Have you looked through the fault codes thread on this forum? Yes it does sound like a fault on the module. If it’s already had a new motor it looks like even a recon. board would bring your bill into BER territory. 🙁

    September 10, 2009 at 6:03 pm #296747
    jackster
    Participant

    Re: Hotpoint WMA34P

    Got it sorted! It was the PCB, luckily I had one a scrapper of the same model and it worked a treat. Cheers all.

    September 11, 2009 at 9:36 pm #296748
    jackster
    Participant

    Re: Hotpoint WMA34P

    jackster wrote:Got it sorted! It was the PCB, luckily I had one a scrapper of the same model and it worked a treat. Cheers all.

    Or so I thought! It is working fine until the final spin then stops, If I select spin manually it spins great? Any Ideas?

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.