Ariston A1635 Error code 10

Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Ariston A1635 Error code 10

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • September 16, 2009 at 8:14 pm #48651
    N20Y1D
    Participant

    My washing machine is playing up again and this time its giving 10 flashes, have tried using the search facility but it seems to show every fault apart from this.

    Can anyone help??

    September 16, 2009 at 8:48 pm #297259
    helo_75
    Participant

    not sensing pressure switch

    could just be pressure switch , but pcb failure is more common

    September 16, 2009 at 8:50 pm #297260
    helo_75
    Participant

    oh, and its worth making sure the connections on the pcb are ok too.. plug out of course

    September 16, 2009 at 9:07 pm #297261
    N20Y1D
    Participant

    helo_75 wrote:oh, and its worth making sure the connections on the pcb are ok too.. plug out of course

    Thanks, i’ve just found this:

    F10: No full and empty signal
    • Check the efficiency of J3 connector contacts on the card
    • Check pressure switch status checking J3 wiring connector pins:
    – 2-4 ohm continuity – tub empty
    – 2-3 ohm continuity – full tub
    – 2-1 ohm continuity – tub overfilled, at least halfway up door glass
    • Check wiring of connector J3/Pressure switch
    • Replace Pressure Switch
    • Replace Card.


    As its the second time the machine has packed up within the last couple of months and its over three years old now so thinking of cutting my losses to be honest, but before i do what would the cost of parts be? I’m really useless with electronics so its a bit daunting.

    Thanks

    September 16, 2009 at 9:25 pm #297262
    helo_75
    Participant

    sily money depending on serial number if its the board
    typical indesit tat
    me? id cut my losses and buy a proper machine.. like a bosch or something of that caliber

    September 16, 2009 at 9:50 pm #297263
    N20Y1D
    Participant

    helo_75 wrote:sily money depending on serial number if its the board
    typical indesit tat
    me? id cut my losses and buy a proper machine.. like a bosch or something of that caliber

    Thanks for your help with this.

    Was just looking at a Bosch, the WAA28165 – looks like i can pick up it for just under £300. do you have any knowledge of this model?

    September 16, 2009 at 10:09 pm #297264
    helo_75
    Participant

    its a good price if you can get it at that

    fill yer boots

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.