Hoover HSWD166-80 Motor plug burnt out

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Hoover HSWD166-80 Motor plug burnt out

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • September 21, 2009 at 5:13 pm #48753
    Bernie
    Participant

    Hoover HSWD166-80
    Motor plug burnt out, have cut off the end of the motor plug with the burnt bit, three wires red, green & blue and refitted them singly
    I know that the red wire is the end one, only not sure which way the other two go have wired it as below
    1 red
    2 green burnt off
    3 blue burnt off
    4 blue
    5 Red
    6 Green
    7 Yellow

    The machine will now only fast spin even if it is on wash

    Thanks Bernie

    September 22, 2009 at 7:43 am #297650
    Martin
    Participant

    Re: Hoover HSWD166-80 Motor plug burnt out

    Let me have your email address Bernie and I’ll send you the wiring diagram. 🙂

    September 22, 2009 at 7:45 pm #297651
    Bernie
    Participant

    Re: Hoover HSWD166-80 Motor plug burnt out

    Thanks for the wiring diagram Martin. I have wired it correctly.

    Do you think that the module/PCB will need changing as it spins on wash?


    Bernie

    September 23, 2009 at 1:11 pm #297652
    electrofix
    Moderator

    Re: Hoover HSWD166-80 Motor plug burnt out

    check the tacho is giving an output and this signal is getting to the pcb

    check motor triac for short circuit


    hope this helps

    Dave

    September 23, 2009 at 1:44 pm #297653
    Martin
    Participant

    Re: Hoover HSWD166-80 Motor plug burnt out

    electrofix wrote:check motor triac for short circuit

    Ditto on Dave’s comment. It could be that being as the motor plug burnt out (not sure why but no matter) then it may well have blown the motor control triac on the board. If you look carefully at the surface components on the PCB I think the motor triac is marked ‘TR1‘

    September 24, 2009 at 6:52 pm #297654
    Bernie
    Participant

    Re: Hoover HSWD166-80 Motor plug burnt out

    Thanks to both of you for the info will have a look.

    Bernie

    September 25, 2009 at 4:57 pm #297655
    MickGeorge
    Participant

    Re: Hoover HSWD166-80 Motor plug burnt out

    Trust you have checked area for signs of a leak – I had one not so long had burnt out due to leak from cracked drum (coin damage about half way up – leaking but only about a tablespoon full per wash but sraight onto motor connector block)

    Mick

    September 25, 2009 at 5:59 pm #297656
    timdowning
    Participant

    Re: Hoover HSWD166-80 Motor plug burnt out

    On this range of washer dryers its common to get a leak from the blower motor / fan duct. It perfectly runs down the back of the tub into the motor block.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.