Home › Forums › Public Support Forums › Help And Support › Washing Machine Help Forum › Zanussi FL1085 washing machine not heating up
- This topic has 4 replies, 2 voices, and was last updated 16 years, 6 months ago by
geraldferreira.
-
AuthorPosts
-
October 7, 2009 at 2:54 pm #49159
geraldferreira
ParticipantZanussi FL 1085 stopped heating up. Took the back off checked the element and although it measured 22ohms but it showed some leakage to earth, so ordered element from UKW and replaced, but no change, still does not heat up. I checked the thermostat and it measured open circuit, which I presume is correct when cold. Other than not heating up the machine performs all the correct cycles. Is there something I am missing.
Please advise.
Gerald FerreiraOctober 7, 2009 at 4:21 pm #298915TheSpinDoctor
ParticipantRe: Zanussi FL1085 washing machine not heating up
Hi.
There should be some resistance across the NTC sensor. If not, that could very well be the problem although I would also suggest you check the air chamber.
October 7, 2009 at 7:18 pm #298916geraldferreira
ParticipantRe: Zanussi FL1085 washing machine not heating up
TheSpinDoctor wrote:Hi.
There should be some resistance across the NTC sensor. If not, that could very well be the problem although I would also suggest you check the air chamber.
Thank you, is the NTC sensor the thermostat? if so it is definately O/C, I shorted out the leads to it with no change to the element heating up. Both air chambers seems to operate when the water lever rises. I also blew into them and certanly the contacts switched over. But now I think I have really broken it, I decided to pull out all the connectors on the circuit board to clean them, put them back and now no matter what programm you put it on it cycles right through at great speed, not waiting to finish one thing before proceeding onto the next. WHAT HAVE I DONE????
October 8, 2009 at 4:02 pm #298917TheSpinDoctor
ParticipantRe: Zanussi FL1085 washing machine not heating up
Well, it soungs like you may have a timer fault there. If so, this could now be getting a little pricey. Either that or you have wired it up wrong somehow.
October 8, 2009 at 6:28 pm #298918geraldferreira
ParticipantRe: Zanussi FL1085 washing machine not heating up
TheSpinDoctor wrote:Well, it soungs like you may have a timer fault there. If so, this could now be getting a little pricey. Either that or you have wired it up wrong somehow.
Hi
I have rechecked the connections and I am sure its is connected correctly, maybe I just aggravated the fault on the timer board. I looked up for a replacement on the UKW parts but I didn’t see one available. Would you know where I can get one from.
Many thanks -
AuthorPosts
- You must be logged in to reply to this topic.
