zanussi zwf1237 e80

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi zwf1237 e80

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • October 17, 2009 at 9:56 am #49386
    wilf
    Participant

    washer showing E80 recirc pump completely burnt out. fitted new one and display still read E80 so cleared the code by holding start/pause and reset code cleared and machine now fills then goes straight to drain. I can skip to select spin and get motor action I’m thinking the boards gone west but would be gratefull for any other ideas.

    wilf

    October 17, 2009 at 2:48 pm #299724
    cab
    Participant

    Re: zanussi zwf1237 e80

    If you have changed the pump the onlt things left are wiring and pcb for the E80 codes

    October 17, 2009 at 8:30 pm #299725
    lerch
    Participant

    Re: zanussi zwf1237 e80

    If circ pump go’s it normal takes out the pcb so check for marks etc.

    October 17, 2009 at 11:07 pm #299726
    leavemetogetonwithit
    Participant

    Re: zanussi zwf1237 e80

    This might interest you.
    zwd1472w
    Mike.

    October 18, 2009 at 9:51 am #299727
    TheSpinDoctor
    Participant

    Re: zanussi zwf1237 e80

    It is the board, no question. When the coil on the pump goes, so does the triac on the board.

    October 19, 2009 at 7:20 am #299728
    wilf
    Participant

    Re: zanussi zwf1237 e80

    thanks for all your help looks like BER!!

    wilf

    October 19, 2009 at 10:50 pm #299729
    leavemetogetonwithit
    Participant

    Re: zanussi zwf1237 e80

    Have a picture of the board I did, showing the AC switch concerned if you’re interested in trying to repair it. It’s labelled TYACS3 and is in one corner of the board, easy to find. Replacement component costs pennies from RS. If you send me your e-mail address I can send the pic. and a link to the spare.
    Mike.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.