Neff T1872NO/01 hob.

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Neff T1872NO/01 hob.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • November 10, 2009 at 8:43 am #50027
    aqualectric
    Participant

    Neff T1872NO/01 ceramic hob. FD 8307.

    This hob uses the touch sensitive control module below the glass. Plates check out OK, but 2 do not function. Module shows no signs of burning and the wiring is intact. I am pretty sure it’s the module ATM, but just looked up the price…… 😯 😯 £243 from BSH.

    Moral support required!! 😉

    Steve.

    November 10, 2009 at 8:45 am #303071
    Jonah
    Participant

    Re: Neff T1872NO/01 hob.

    Hi Steve, has it got a seperate filter card for the mains supply, I had a Neff induction hob with R/H side not working and it was the filter card not the touch control faulty

    November 10, 2009 at 9:01 am #303072
    aqualectric
    Participant

    Re: Neff T1872NO/01 hob.

    Thanks, Jonah. Checked the parts list and a filter card is not listed. To be honest, the hob is very basic internally; there are the hotplates, the wiring, the terminal block and the module control. That’s about it.
    Is the filter card in the terminal block housing or in the module or is it separately mounted? As I say, it’s not on the parts list……. 😕

    Cheers,

    Steve.

    November 10, 2009 at 11:29 am #303073
    Jonah
    Participant

    Re: Neff T1872NO/01 hob.

    I reckon it has to be touch control if a filter card is not listed, TBH they are normally only on induction hobs not normal ceramics, BSH parts are really expensive got the same problem with a built in microwave gonna cost about £350 to repair it 😯

    September 8, 2010 at 6:45 pm #303074
    suedehead1
    Participant

    Re: Neff T1872NO/01 hob.

    raising an old thread, i went to one of these today and one of the hotplates isnt working the botttom of the hob cannot be removed because of bad installation, and the hob is stuck to the worktop with sealant, anyone got any ideas how it can be repaired please.

    September 8, 2010 at 7:09 pm #303075
    Jonah
    Participant

    Re: Neff T1872NO/01 hob.

    Untill you get it out there ain’t much you can do, typical DIY install by the sound of it mate :bang:

    September 8, 2010 at 7:40 pm #303076
    suedehead1
    Participant

    Re: Neff T1872NO/01 hob.

    thanks for the reply, just as i thought whoever installed it has not left access to the underside, the hotplate required is listed at £170 so that should be enough to put them off.

  • Author
    Posts
Viewing 7 posts - 1 through 7 (of 7 total)
  • You must be logged in to reply to this topic.