Bosch WVT1260GB/01

Re: Bosch WVT1260GB/01

Have you checked there is water entering the little chamber.

The Element should have Resistance: 34.5- 36.5Ω

The NTC operating range is between –5 °C and 103 °C.
The programme continues cold in the event of an interruption or a
short- circuit. The test programme displays “NTC short circuit” or “NTC
interruption”.

Temperature in °C Resistance in kΩ
10 °C 8.5–10.6
20 °C 5.4–6.5
30 °C 3.5–4.3
40 °C 2.3–2.9
50 °C 1.5–1.9
60 °C 1.1–1.3
66 °C 0.9–1.1
86 °C 0.45–0.55

If not go into test program, follow these instructions

1. Selecting the test program
Observe correct method for setting program selector!
Activate
test program:
Set program selector to OFF position
Press START button for at least 3s
There while set program selector to a test program:
-Program Easy Care 40°
-> Single component test (see 2.)
-Program Cotton/Coloureds 90° ⊕
-> Automatically test procedure (see 3.)
-Program Cotton/Coloureds 40° (Chinese variant)
Program Cotton/Coloureds 60° (European variant)
-> Test and demo program LCD-display (see 5.)
Display
If fault is detected, Fxx / Exx* is flashing
Error is displayed only one time
Icons rinsing, sun and spinning illuminate,
no residual term, display active
Icons rinsing, sun and spinning illuminate,
no residual term
display active
Start
test program:
Press START button at:
– Single component test (see 2.)
test program starts automatically at:
– Automatically test procedure (see 3.)
– Test and demo program LCD-display (see 5.)
Abort
test program:
Adjust program selector or press START button at:
– Single component test (see 2.)
– Automatic test sequence (see 3.)
Switch OFF appliance at:
– Test and demo program LCD-display (see 5.)