- This topic has 2 replies, 3 voices, and was last updated 16 years, 4 months ago by
.
Viewing 3 posts - 1 through 3 (of 3 total)
-
Posts
-
This machine has low water pressure at spray arms. Because it was intergrated and 6.30 tonight I didnt pull it out. I assumed it would be a circ pump complete but see its made up in component form. Would i be correct in assuming motor or how often does impellor get a partial blockage? The cost of parts says I investigate further. The m/c is only out of 2 year warranty.
Thanks Geoff
Geoff , as you look down into the sump , there is a hole at approx the 3 o’clock position. This is where the water gets sucked into the circ motor…have a poke around in this opening. I have had quite a few faults like this where a foreign object has blocked the hole and therefore restricted water flow…plastic packet rip-offs are a favourite .
Viewing 3 posts - 1 through 3 (of 3 total)
- You must be logged in to reply to this topic.