- This topic has 5 replies, 4 voices, and was last updated 16 years, 4 months ago by
.
-
Posts
-
M9010w,
Block connector on the end of module burned and module damaged,
Suspect water dripped on it.
Number on old module 546052200
number on new module 546052201
New one has plastic surround for connector block to locate but you have to
cut locating bits off plug to make it fit
When fitted, All programmes wrong, spin is rinse, wash might be wash etc
Both Connect and Masterpart show this to be right Module,
Is their a modification or are they supplying wrong module
😕Re: Servis Module
These modules often burnt and if you had to break off the old plastic plug and replace with amp tags then you could have put the wires back incorrectly. The wires will have numbers on them, 1-10 so make sure they are in order. The 1 on the module no. is just the supplier to Servis but if the old module was there from new then you have the right part.
RobRe: Servis Module
Serial No 20034122801
I hack sawed only two connectors off end and put tags on.
No mistakesRe: Servis Module
Module definitely correct. As you will know the module controls everything on this machine and there are no modifications so perhaps it is faulty from new which is not unheard of but unusual. I’ve never come across this particular problem so have suggested all I can.
Good luck and I will look forward to the solution.
Rob
- You must be logged in to reply to this topic.