Indesit D/Washer IDL40UKC – no heat

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Indesit D/Washer IDL40UKC – no heat

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 9, 2009 at 5:15 pm #50806
    MickGeorge
    Participant

    Hi folks

    Went to this slimline d/w and m/c not heating – going thru prog and water cold but no fault indication throwing up.

    Checked out heater that ok. Inpected PCB that looks ok to.

    Am i right in thinking this is proberbly a NTC fault? Looks like one fitted near the end of the heating element (or is that a thermostat?) and when I tested it the resistance seemed low for a NTC (altho i was struggling a bit to get on the connections properly).

    Had similar fault on a candy washer that was doing same thing and that was low resitance NTC.

    Anyone had similar prob?

    Thanks – any help appreciated.

    Mick

    December 9, 2009 at 7:54 pm #306042
    johnnyj
    Participant

    Re: Indesit D/Washer IDL40UKC – no heat

    Itl be the 100 bit timer, 2 pcbs up to ser n/o 70914999 C00142139 from ser n/o 709150000 part n/o C00259733 hope this helps JJ

    December 10, 2009 at 8:59 am #306043
    MickGeorge
    Participant

    Re: Indesit D/Washer IDL40UKC – no heat

    Thanks for the reply JJ

    September 12, 2011 at 10:06 am #306044
    cornwell40
    Participant

    Re: Indesit D/Washer IDL40UKC – no heat

    Is there a part number change on the earlier one as Connect don’t recognise the part number. Its a IDL40 UKC and numbers are 605228407 and 643752100000. Peed off with these pieces of crap cos I used to put 12 months guarantee on these and they are failing within the period a bit too often 👿 👿 .

    Tony

    September 12, 2011 at 10:15 am #306045
    iadom
    Moderator

    Re: Indesit D/Washer IDL40UKC – no heat

    C00142139 is the correct part number.

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.