- This topic has 7 replies, 5 voices, and was last updated 16 years, 3 months ago by
.
-
Posts
-
Machine not heating. Checked rear stat pair and heater, all OK. Found another stat mounted high up at the front, also reading short circuit. What else should I check? The dryer will also need the later type door latch as it now only runs when you hold the door shut and has been jumping open during use.
Re: Creda TCR2
Quite often the timer gives this fault Phidom, had it a couple of times with Indesit group stuff.Had a Hotpoint a few weeks ago with no drum movement, after checking cap, motor & wiring was running out of ideas, tapped timer with screwdriver handle & off she went 😯
Re: Creda TCR2
I fitted the new type door latch kit but customer says door still keeps opening by itself. Any suggestions (ones not involving skips, rubbish dumps etc. preferred)?
Re: Creda TCR2
have never had a problem you cant fit them wrong so is the door twisted failing that i would try another latch kit did you fit latch and springlatch assy
Re: Creda TCR2
Got one of these with door which has to be held shut with tape. Latch itself, on the door, looks fine. What’s behind the front panel?
Mike.Re: Creda TCR2
you just get a new latch kit C00257618 comes with the catch and part for front panel change both parts.
- You must be logged in to reply to this topic.