Miele W842 Washer

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele W842 Washer

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • December 22, 2009 at 9:06 am #51124
    mike100
    Participant

    Coming in to spin cycle gave a bang then stopped. Not electrical bang, now just rinse light flashes.
    Customer rang Miele who said it was unbalanced load.
    Checked connectors on module but not taken motor out yet.
    Know all customer doesn’t thinks its brushes even though it is 11 years old.
    it was spinning ok up to this point.
    is there a reset for unbalanced load?
    Thanks
    Mike

    December 22, 2009 at 9:44 am #306990
    philfish
    Participant

    Re: Miele W842 Washer

    rinses usually means no signal back from tacho within a couple of seconds check the usual brushs,tacho,field etc.

    hth phil

    December 29, 2009 at 4:12 pm #306991
    dal
    Participant

    Re: Miele W842 Washer

    sounds as though brushes worn downand was arking May have taken out the power board Check motor brushes first DAL…………. happy hunting

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.