Motor Pulley Washing machine

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Motor Pulley Washing machine

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • December 29, 2009 at 10:46 pm #51247
    M1
    Participant

    Hi

    I have a customer CDA motor in my work shop & the front motor bearing has gone, I am struggling to get the motor pulley off, tried 3 times method:
    Blow torch (red hot pulley) three legged puller & can’t get the pulley to move !!

    I know most of the motor shafts now days have teeth on, & the pulley’s are pressed on in the production process.

    Anyone had any luck removing pulleys, this was never a problem with the larger pulleys on the old induction motors.
    😡
    Thanks !

    December 29, 2009 at 11:10 pm #307379
    leavemetogetonwithit
    Participant

    Re: Motor Pulley Washing machine

    Last time I managed it was with an old Hotpoint about twenty years ago when they had flats on the end of the pulley. You’ll probably end up destroying the windings with heat or pressure if it hasn’t happened already.
    Mike.

    December 30, 2009 at 8:05 am #307380
    robbra
    Participant

    Re: Motor Pulley Washing machine

    I tried on a Servis induction motor just the once and it wouldn’t budge.
    If yours is that hard to get off could you get it back on again?
    Rob

    December 30, 2009 at 8:22 am #307381
    Simon46
    Participant

    Re: Motor Pulley Washing machine

    Go to an armature winders. for 20 quid they will use a press.

    S.

    January 5, 2010 at 10:47 pm #307382
    M1
    Participant

    Re: Motor Pulley Washing machine

    It’s OFF !!
    😆
    Borrowed a hydraulic puller and it came off, did not even have to heat it up.

    Think I now need to puchase a HYDRAULIC PULLER KIT !! 😛

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.