Diamond H electric thermostat wiring

Home › Forums › Public Support Forums › Help And Support › Cooker And Oven Forum › Diamond H electric thermostat wiring

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 17, 2010 at 11:11 pm #51709
    High_Pressure
    Participant

    I’m trying to replace an older Diamond H thermostat but the connections are slightly different and before I make a mistake, would like some advice.

    The cooker is a Parkinson Cowan 1200G. The original stat is a 47THC9/F8 being replaced by a ET52001/F8. On the old stat there are two connectors on the back, “F” and “G”. On the new one there are two, “A” and “B”. Logic would suggest F=A and G=B but I’m not quite sure. The rest of the connectors are numbered and line up.

    Can anyone advise?

    Regards,
    David

    January 19, 2010 at 12:18 am #309050
    Penguin45
    Participant

    Re: Diamond H electric thermostat wiring

    If A+B were a make-and-break switch and F+G is a make-and-break switch (Check contacting with your test meter), polarity won’t matter as it’s an AC circuit.

    I can find nothing relating to a 1200G cooker – check model number or better still find the pNc number.

    Penguin45.

    January 19, 2010 at 8:03 pm #309051
    High_Pressure
    Participant

    Re: Diamond H electric thermostat wiring

    Thanks for the advice – I’ll try the test meter when I get a chance to unassemble it again. It the mean time, I’ve found the original owners handbook. Part number listed is 311409501 (1998). Model number is R1200GRN.

    Regards,
    David

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.