Prima LPR600/1 Dishwasher

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Prima LPR600/1 Dishwasher

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 18, 2010 at 7:30 pm #51734
    maltheviking
    Participant

    Prima LPR600/1 Built in Cheap cr8p Service no 854560015871

    Not usually stumped with these beggers but I thought I would pass this around on the forum

    Machine fills OK and starts to wash OK, 7 seconds after wash pump starts, it stops for about 2 sec then re starts for another 7 secs 😕 Does this about 5 times then aborts the program and pumps out with four bleeps when empty. No flashing fault code.
    It can then be re started with the same result.
    It has a strange wash pump with a circular heater on the front of, not seen this before.
    My suspicion is the module

    Any help please
    Mal

    January 18, 2010 at 7:52 pm #309125
    Penguin45
    Participant

    Re: Prima LPR600/1 Dishwasher

    Possible earth leak on heater, usually pcb IME.

    Chris.

    January 18, 2010 at 8:01 pm #309126
    maltheviking
    Participant

    Re: Prima LPR600/1 Dishwasher

    Penguin45 wrote:Possible earth leak on heater, usually pcb IME.

    Chris.Hi Chris I did and insolation test on the appliance especially the heater, tried a new ntc. I could only test other components from the module as the eedyot has built it in so it won’t come out from the unit.

    I have just been onto the customer and advised that I am 90{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d} sure it’s the module, left him to decide.

    Would still like to get to the bottom of this

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.