- This topic has 2 replies, 2 voices, and was last updated 16 years, 2 months ago by
.
-
Posts
-
hi all ive a hotpoint aquarius wf 220 36162423 door number , its really noisy on spin and feels rough turning the drum by hand , has anyone replaced bearings on this model ? looking at doing the job myself if its not too bad thanks 🙂
Re: hotpoint WF 220 bearing
Big fun – not.
Front off, tub out and spilt, measure shaft at front bearing.
If it’s 35mm, you can buy a BEARING AND SEAL KIT and if needed, a DRUM SUPPORT.
If the shaft is 30mm, you can get a BEARING AND SEAL KIT. However, if the shaft shows the slightest signs of damage, you need to replace it and it isn’t a spare part. You’ll need to buy a TUB REAR HALF and a 35MM DRUM SUPPORT.
Apart from that, it’s out with the sledge hammer and drift.
Penguin45.
Re: hotpoint WF 220 bearing
cheers penguin , although i wouldnt be afraid of the job it sounds a bit long winded and if something goes wrong there is the m/c on the kitchen floor in bits , which of course herself would be thriled with i may splash out the 300 euro for a new model and take the hotpoint out to the shed for a bit of investigation .thanks for the speedy reply as always top notch fella
- You must be logged in to reply to this topic.