- This topic has 3 replies, 3 voices, and was last updated 16 years, 2 months ago by
.
-
Posts
-
On spin cycle it will spin from 11 minutes down to 8 then will jump to 1 minute and stop.
Brushes were gone, fitted new ones but still doing the same thing. Any ideas??Re: Bosch E-Nr: WF02865UK/01 E.D 8308600273, W.m
It’s probably fault code 1.
I can’t remember if that is pump, motor or heater though 😕
Re: Bosch E-Nr: WF02865UK/01 E.D 8308600273, W.m
This has been discussed many a time on this site.
A search should reveal all.
For me I’ve found that running half a dozen cycles can eventually allow the brushes to seat enough for the module to ‘like’ them.
If no joy after that you will probably find the fault is due to low insulation of the motor.
Do remember that the spin on its own never will do a full 11 minute spin anyhow.
Normally 1 minute left in the display is a heater related fault.
- You must be logged in to reply to this topic.