Whirlpool Water Dispenser

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Whirlpool Water Dispenser

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 25, 2010 at 12:40 am #51942
    subs
    Participant

    Side by side F/F S20D RSB33-A/G 11 0447 026461
    This ff is not dispensing water. Checked valve ok. I have traced the blockage to the length of tubing in the door. When i disconected the tube at the bottom the water pumps out when i press the dispenser lever. I managed to push a piece of wire about a foot up the tube at the dispenser end and about 2 feet up the tube from the bottom end of the door but its still blocked. How do you replace the tube in the door? I removed the front control board and undid the 4 screws on the casing of the dispenser but could not remove it. It was still stuck solid but i could not work out what was holding it.

    Any help please

    Subs

    January 25, 2010 at 8:48 pm #310071
    Alanj
    Participant

    Re: Whirlpool Water Dispenser

    Subs, is it possible that the blockage is ice? The water is probably frozen in the tube, so replacing it won’t help. Insulation in door is likely broken down and requires new door. 🙁

    Alan

    January 27, 2010 at 11:28 am #310072
    thankevans
    Participant

    Re: Whirlpool Water Dispenser

    On the ice maker underneath on th right is a rectangle button make sure this is pushed in as this helps that problem.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.