beko drcs68w

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › beko drcs68w

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • January 27, 2010 at 6:55 pm #52026
    robbo1973
    Participant

    this guy is complaining of no heat on the sensor cycle but if he puts it onto the timed cycle it runs ok.are there any issues on these as i have never seen one before.any info appreciated.

    cheers chris

    January 27, 2010 at 8:20 pm #310361
    Galway
    Participant

    Re: beko drcs68w

    try running the test program from page 7 on known error codes and if everything works then its got to be the control board

    January 27, 2010 at 9:27 pm #310362
    helo_75
    Participant

    unless its in a cold room

    we’ve discussed this a lot recently.. if its under 5 degrees, the ntc is way out of tolerance

    January 27, 2010 at 9:45 pm #310363
    robbo1973
    Participant

    Re: beko drcs68w

    thanks very much for replies ,it is in a warm kitchen and i will try the test programme

    January 28, 2010 at 8:07 am #310364
    funkyboogy
    Participant

    Re: beko drcs68w

    could aslso be dust trapped behind sensor…remove and clean
    should be inside front lip of drum at bottom,,

    ally

  • Author
    Posts
Viewing 5 posts - 1 through 5 (of 5 total)
  • You must be logged in to reply to this topic.