zanussi zwd1471

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › zanussi zwd1471

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 1, 2010 at 6:10 pm #52128
    mikehha
    Participant

    need help with this one lads after 2 hours i`m pulling my hair out what little i`v got. ! You can start any wash prog after 2-3 min m/c gose back to start time the start/pause light flashes m/c stops. on entering diognistics and you get various fault codes you can also only get the pump cycle to run for about 10sec its not the board as i have already changed it.(same fault befor and after)

    February 1, 2010 at 6:24 pm #310691
    neilsukwg
    Participant

    Re: zanussi zwd1471

    Eliminate carbon brushes and heating element, especially low insulation faults

    February 1, 2010 at 7:06 pm #310692
    mikehha
    Participant

    Re: zanussi zwd1471

    No earth leakage on element, carbons at 70{e5d1b7155a01ef1f3b9c9968eaba33524ee81600d00d4be2b4d93ac2e58cec2d}

    February 1, 2010 at 7:35 pm #310693
    leavemetogetonwithit
    Participant

    Re: zanussi zwd1471

    40 megohms of insulation resistance (especially dryer element) is low enough to trigger such faults. It says so in the service manual.
    Mike.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.