Miele dishwasher g858

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › Miele dishwasher g858

Viewing 13 posts - 1 through 13 (of 13 total)
  • Author
    Posts
  • March 15, 2004 at 10:14 am #5229
    Scotty
    Participant

    can anyone help, the bottom of the three spray arms is not working, cannot find any blockage,and the other 2 are fine. 😳

    March 15, 2004 at 12:12 pm #110011
    Dave_Conway
    Participant

    Re: Miele dishwasher g858

    Scotty,

    I phoned our local Miele agent today to order a few parts and asked them about this while on the phone. They need more info, apparently there are 10 versions of G858, there should be something else after it, like plus, or similar. They think there may be a solenoid or water directing device that alternates the water supply between the upper and lower spray arms, probably stuck in the “upper” position.

    If you let me know the rest of the model number, I’ll try and find out a bit more for you.

    Dave.

    March 16, 2004 at 8:48 am #110012
    Scotty
    Participant

    Re: Miele dishwasher g858

    Thanks dave. The numbers i have are g858scu1plus ser num 26/63749552 😛

    March 16, 2004 at 11:49 am #110013
    Dave_Conway
    Participant

    Re: Miele dishwasher g858

    I just spoke to them again, during the conversation I cheekily asked if Miele would supply a parts/info cd.

    They do ! And it’s only about £17 😯

    Anyway I ordered one which should be here in the next couple of days, so I’ll be able to have a better look then.

    Dave.

    March 16, 2004 at 1:36 pm #110014
    eastlmark
    Moderator

    Re: Miele dishwasher g858

    Just a thought Scotty, its not set on a half load programme is it?

    oh and Dave, Ill have one of them discs if you get any spare.
    Mark.

    March 16, 2004 at 6:27 pm #110015
    Scotty
    Participant

    Re: Miele dishwasher g858

    I thaught the half load setting was a possibility initially, but it does not seem to be the answer. I would not rule anything out. ❗

    March 22, 2004 at 1:45 pm #110016
    Dave_Conway
    Participant

    Re: Miele dishwasher g858

    The dishwasher does definitley have what is called a “circulation valve” part number is 5268861. It may not be that of course but it must be the obvious choice if the half load option has been eliminated.

    Dave.

    March 22, 2004 at 9:15 pm #110017
    Scotty
    Participant

    Re: Miele dishwasher g858

    Hi Dave

    Is this circulation valve a water valve or some kind of solonoid

    scott 💡

    March 22, 2004 at 10:11 pm #110018
    Dave_Conway
    Participant

    Re: Miele dishwasher g858

    It’s hard to tell really Scotty, the drawing isn’t that clear and the desription is as I desribed above.

    Probably both I would imagine, a valve that is controlled by a solenoid 😕

    Dave.

    March 23, 2004 at 12:45 am #110019
    Penguin45
    Participant

    The AEG circulation valve uses an AKO timer type motor to regulate their “distributor valve”. Perhaps a variation on the theme?

    JAT,
    Penguin.

    March 23, 2004 at 2:13 pm #110020
    Seamy
    Participant

    Re: Miele dishwasher g858

    Off the top of my head, Miele dishwashers have a “Top Solo Function” this is similar to 1/2 load, a solenoid near the circulation pump is used to allow or prevent water going to the lower spray arm, this sticks sometimes with debris grease etc, from memory i’ve never had to replace any, just had to remove & spray with wd40 etc to clean & put back in place, hope this is helpful.

    Seamy

    March 26, 2004 at 9:00 am #110021
    Scotty
    Participant

    Re: Miele dishwasher g858

    Dave are their any test progs or fault finding charts on the disk
    Scott

    March 26, 2004 at 11:26 am #110022
    Dave_Conway
    Participant

    Re: Miele dishwasher g858

    Scotty wrote:Dave are their any test progs or fault finding charts on the disk
    Scott

    Sadly no. It’s just a parts identification disk, there is however a technical support telephone number on the paperwork that came with it to activate the disk, it may be worth a try, it’s 01235 233141

    Dave.

  • Author
    Posts
Viewing 13 posts - 1 through 13 (of 13 total)
  • You must be logged in to reply to this topic.