PARKINSON COWAN GAS COOKER RG60DLBKN

Home › Forums › Trade Technical & Spare Parts Forums › Trade Technical Enquiries › PARKINSON COWAN GAS COOKER RG60DLBKN

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • February 8, 2010 at 8:15 pm #52340
    funkyboogy
    Participant

    oven ignition keeps sparking after oven has lit ,
    havent seen this one b4 , ant ideas

    cheers ally

    February 8, 2010 at 9:38 pm #311402
    washermanuk
    Participant

    Re: PARKINSON COWAN GAS COOKER RG60DLBKN

    Hi matey yes had this fault before thinks its to do with ionization? needs the flame to complete the circuit and stop the ignition :rolls: adjusting the spark probe gap may help or a fault with the ignition probe? Found this but 2 technical for me 😯
    The problem with most prior piezoelectric ignition systems, including that of Berlincourt, has been that ionization shorts out the series spark gaps when such gaps are located too close to the burner ports. Positioning the spark gaps far enough from the burner ports to prevent shorting out due to ionization often results in erratic ignition or no ignition at all. Moreover, most, if not all, conventional systems cannot be adapted for heavier as well as lighter than air gases and are usually limited to one such category. I could be totally wrong tho 😳

    February 8, 2010 at 10:13 pm #311403
    Jazzmeister
    Participant

    Re: PARKINSON COWAN GAS COOKER RG60DLBKN

    Probably just a faulty ignition unit matey…..The re-ignition part inside is not registering the heat! if that were to fail ht lead or igniter!

    Jazz

    February 8, 2010 at 11:01 pm #311404
    funkyboogy
    Participant

    Re: PARKINSON COWAN GAS COOKER RG60DLBKN

    CHHERS …will order ht lead and ignition unit

    will update asp

    cheers ..

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.