Fisher & Paykel Smartdrive MW058

Home › Forums › Public Support Forums › International Forums › Australasian Appliance Forum › Fisher & Paykel Smartdrive MW058

Viewing 8 posts - 1 through 8 (of 8 total)
  • Author
    Posts
  • February 8, 2010 at 9:44 pm #52344
    sivam
    Participant

    My machine is not filling even with cold water. It gets so far very slowly then starts to do the fast beeping. The hot and cold lamps are flashing. I have checked all filters and hoses. The diagnostic test did not light any lamps along the top. If I manually fill for the wash and then again for the rinse everything works fine. (If I can find out the problem the electrical engineer in the house may actually look at it !!!)

    Its a great site,
    Thanks… 😯

    February 9, 2010 at 1:42 am #311413
    Penguin45
    Participant

    Re: Fisher & Paykel Smartdrive MW058

    Run the diagnostics in the Sticky at the top of the forum. You’ll probably find there’s a fill time-out problem pointing at the cold water valve.

    Penguin45.

    February 9, 2010 at 12:16 pm #311414
    sivam
    Participant

    Re: Fisher & Paykel Smartdrive MW058

    I did the diagnostics according to your sticky no lights lit up at the top.
    from the service manual I did the test at 8.3 to test the pump and water valves. Pump worked. Cold worked. Hot no water. Is this the problem ?

    Thanks Sivam

    February 9, 2010 at 8:48 pm #311415
    Penguin45
    Participant

    Re: Fisher & Paykel Smartdrive MW058

    Sounds resaonable – hot water is only called for on the wash programme, not rinse, so the proportional cold water valve is only slightly open.

    Valve should read 15 ohms if metered.

    Penguin45.

    February 9, 2010 at 8:56 pm #311416
    sivam
    Participant

    Re: Fisher & Paykel Smartdrive MW058

    Thanks I should be able to get this checked. Do you have a part number ?

    February 9, 2010 at 9:31 pm #311417
    Penguin45
    Participant

    Re: Fisher & Paykel Smartdrive MW058

    426142

    Penguin45.

    February 27, 2010 at 11:30 pm #311418
    sivam
    Participant

    Re: Fisher & Paykel Smartdrive MW058

    Hi

    We now have the part. How do we remove the bracket to fit this? They don’t seem to be screws holding it in are they something you need a special tool for ?

    Wilsivam

    February 28, 2010 at 12:37 am #311419
    Penguin45
    Participant

    Re: Fisher & Paykel Smartdrive MW058

    HERE.

    Penguin45.

  • Author
    Posts
Viewing 8 posts - 1 through 8 (of 8 total)
  • You must be logged in to reply to this topic.